●Be careful to handle high-power lighting equipments which get very hot.
●Please check if there are sprinkler and something flammable around the
place equipments set on.
●To protect lights from damages,we don't offer shutters & scrims to be used with HMI Parlight,Goya,with bared bulbs such as Openface lights.
●If necesarry,please put a protective coating on the floor and fasten the lights in place by wires or ropes.
●When you use HMI light by changing the volume on a ballast,especially to
minimum,please get the volume on the ballast maximum and run more than 5 minutes
before turning off the light.
●To prevent from overheating,do not adhere HMI ballasts to each other and
avoid direct sunlight.
●Do not stick filters and rain covers to the lights tightly with tapes.
●Make sure that the input valtage is 100V,not 200V,when running 100V-Tungsten
and Kino-Flo lights.
●Please refrain from lighting continuously at extreme low-angle.It will
cause damage to the lights.
●Please make the power wirings sufficient and check the load capacity.
●o reduce the risk of electric shock or a damage to the qquipments,
do not disable the power code grounding plug and ELB.
●Please use cable protector and barrier-free slope mat for other people's
comfort and safety.
●Do not refuel portable generators during operation.
●Please provide adequate ventilation when running partable generators.
●After wiring,please check the voltage before turning on the lights.
※Please contact us immediately when equipments get broken or don't work.